135
TECHNICAL
SPECIFICATIONS
G
5.2.2 E9000 Controller
5.2.3 PowerPro Controller
The controllers are designed with “closed loop feedback” that provides immediate electronic
feedback to hold handpiece speed constant, even with increasing load. Low input voltage may
result in reduced speed.
NOTE: There are no toxic components used in the manufacture of the Advantage, Power
Pro and
E9000 Systems. After the useful life of the product, dispose of components and service parts properly.
Typical Operating Requirements: E9000
E9000G E9000J
Input Voltage: 115 VAC 230 VAC 100 VAC
Frequency: 50/60 Hz 50/60 Hz 50/60 Hz
Power Consumption: 250 VA 250 VA 250 VA
Handpiece Output: 180 VA 180 VA 180 VA
Line Frequency Leakage: Less than 100 ma
Fuses: Reference the specification label located on the back of the
controller.
Output: 3 phase motor drive and control circuits
Dimensions: 11.75” (W) x 4.63” (H) x 12.25” (D)
29.8 cm (W) x 11.8 cm (H) x 31.1 cm (D)
Weight: 15.4 lbs. (7.0 kg)
Pump Flow Rate: 0 - 150 mL/minute
Typical Operating Requirements: PRO2000
PRO2000I
Input Voltage: 115 VAC 230 VAC
Frequency: 50/60 Hz 50/60 Hz
Power Consumption: 500 VA 500 VA
Handpiece Output: 325 VA 325 VA
Line Frequency Leakage: Less than 100 ma
Fuses: T 8.0 A, 250 V T 4.0 A, 250 V
Output: 3 phase motor drive and control circuits, 325 VA
Dimensions: 11.75” (W) x 4.63” (H) x 12.25” (D)
29.8 cm (W) x 11.8 cm (H) x 31.1 cm (D)
Weight: 17.3 lbs. (7.8 kg)
To Next Page
Loading...
