110
MINI-DRIVER
HANDPIECE
E
1. To insert a bit into the screwdriver.
(a) Unscrew the bit retainer section
(counterclockwise) from the
screwdriver.
(b) Insert the bit into the back of the
screwdriver, tip first.
(c) Slide the bit retainer over the bit and
thread the retainer back on the
screwdriver by turning it clockwise until
tight.
(d) While retracting the locking sleeve on
the Trinkle Chuck attachment, insert the
screwdriver into the chuck and release
the locking sleeve.
PRECAUTION: Ensure that the
screwdriver is securely seated in the
Trinkle Chuck before use.
2. To engage the screwdriver bit into the screw
head.
(a) Insert the head of the screw into the
screwdriver.
(b) Hold the screw firmly and press the
knurled portion of the screwdriver body
forward so the teflon collar snaps over
the head of the screw.
3. To remove the screw, retract the teflon
collar and remove the screw.
To Next Page
Loading...
