ConMed Advantage - Page 99

91
MICROCHOICE
HANDPIECES
C
3.6.3.1 Trinkle Shank Accessories for
the Universal Drill Attachment
1. To insert a Trinkle Shank accessory into the
Universal Drill Attachment:
(a) Pull the Universal Drill Attachment
collet sleeve back.
(b) Align the dimple on the trinkle shank
with the black arrow on the outer collet
sleeve. Totally insert the trinkle shank.
The spring-loaded inner sleeve will
retract.
(c) Release the collet sleeve and rotate the
accessory until it is completely
engaged. Pull the accessory firmly to
ensure proper engagement.
2. To remove accessory, pull back the outer
collet sleeve and remove the accessory.
3.6.3.2 AO Drill Bits for the Universal
Drill Attachment
1. To insert an AO Drill Bit into the Universal
Drill Attachment.
(a) Align the flat portion of the drill shank
with the black arrow on the outer collet
sleeve.
(b) Insert the drill shank into the collet as
far as it will go without pulling back
the collet sleeve. Twist the shank to
make sure it is aligned properly. If it is,
it will not spin in the collet.
(c) Pull back on the collet sleeve and push
the shank completely into the collet.
(d) Release the collet sleeve. The shank is
now locked into the collet. Pull the drill
bit firmly to verify it is properly seated.
2. To remove the drill bit, pull back on the
collet sleeve and remove the bit.