Configuring Advanced Settings
D-Link Unified Wired and Wireless Access System
Oct. 2015 Page 625
D-Link UWS User Manual
Figure 391: AP Profile TSPEC Configuration
The following table describes the fields on the Access Point Profile TSPEC Configuration page.
Caution! If you change any of the settings on the TSPEC Configuration page, the AP radios will restart
when this profile is applied.
Table 358: TSPEC Configuration
Field Description
Radio 1
Radio 2
You configure the TSPEC settings for Radio 1 and Radio 2 separately. Use the radio
button to select the desired radio.
TSPEC Mode Enable or disable TSPEC operation on this radio.
Voice ACM Mode Regulates mandatory admission control (ACM) for the voice access category. The
options are:
• Enabled—A station is required to send a TSPEC request for bandwidth to the AP
before sending or receiving a voice traffic stream. The AP responds with the
result of the request, which includes the allotted medium time if the TSPEC was
admitted.
• Disabled—A station can send and receive voice priority traffic without requiring
an admitted TSPEC; the AP ignores voice TSPEC requests from client stations.
To Next Page
Loading...
