DAHAO A88 - Page 164

Chapter 12 Directions on Coiling, Taping and Zigzag Embroidery
156 BECS-A88/C88 computerized embroidery machine owner’s manual
“+/-” setting.
Select this parameter, input required value in the right side of the screen,
stands for “-” and
for “.” Press to confirm.
11. C39 Spec. Emb. Trim Mode: Low, Above&Low, No Trim
Press the key
or in the right side of the screen for adjustment, and then
press
to confirm.
The following parameters can be set in direction of Machine application 3:
12. D28 Special Head Interval: 1~300.
Destinned value includes: 150, 162, 166, 185, 200, 216, 225, 230, 240, 250, 270,
290, and 300.
Select this parameter, input required value by typing in certain digit. Press the key
to cancel a digit and to cancel all the digits. After input, press the
key
to finish setting. If predetermined value is inputted, there will be a “*”
in front of the digit. If digits 1-9 are inputted, there will be a “
＃” in front of the
digit.
The following parameters can be set in direction of Machine parameter 4:
13. D29 Zigzag Swing Angle: 0~255
Press the key
to cancel a digit and to cancel all the digits. After
input, press the key
to finish setting.
14. D30 Clamp Foot Displace: 0~90
Adjusting the working position of clamp foot: “0--90”; operation ditto. The height
is for every stitch. Press the key
to cancel a digit and to cancel all