Develop ineo 4020 - Universal Setup Menu

User's Guide
- 157 -
Universal Setup menu
Use
To
Units of Measure
Inches
Millimeters
Identify the units of measure.
Note: Millimeters is the factory default setting.
Portrait Width
3–8.5 inches
76–216 mm
Set the portrait width.
Notes:
• If the width exceeds the maximum, then the printer uses the
maximum width allowed.
• You can increase the width in 0.01-inch increments.
• 216 mm is the factory default setting. You can increase the width
in 1-mm increments.
Portrait Height
3–14.17 inches
76–360 mm
Set the portrait height.
Notes:
• If the height exceeds the maximum, then the printer uses the
maximum height allowed.
• You can increase the height in 0.01-inch increments.
• 356 mm is the factory default setting. You can increase the height
in 1-mm increments.
Feed Direction
Short Edge
Long Edge
Specify the feed direction if the paper can be loaded in either
direction.
Notes:
• Short Edge is the factory default setting.
• Long Edge appears only when the longest edge is shorter than
the maximum width supported in the tray.