Develop ineo 4020 - Installing an Internal Solutions Port

User's Guide
- 34 -
4. Push the card firmly into place as shown in the illustration.
Warning—Potential Damage: Improper installation of the card may cause damage to the card and
the controller board.
Note: The entire length of the connector on the card must touch and be flushed against the controller
board.
5. Close the controller board shield, and then the controller board access door.
Note: When the printer software and any hardware options are installed, it may be necessary to
manually add the options in the printer driver to make them available for print jobs. For more
information, see
Updating available options in the printer driver.
Installing an Internal Solutions Port
The controller board supports one optional Internal Solutions Port (ISP).
Note: This task requires a flathead screwdriver.
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional
hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug