Develop ineo 4020 - Placing Separator Sheets; Copying Multiple Pages Onto a Single Sheet

User's Guide
- 98 -
2. If you are loading a document into the ADF tray, then adjust the paper guides.
3. From the home screen, navigate to:
Copy > enter the number of copies >Collate > select the preferred order of pages >
>Copy It
Placing separator sheets between copies
1. Load an original document faceup, short edge first into the ADF tray or facedown on the scanner
glass.
Notes:
- Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as
magazine clippings) into the ADF tray. Place these items on the scanner glass.
- The ADF indicator light comes on when the paper is loaded properly.
2. If you are loading a document into the ADF tray, then adjust the paper guides.
3. From the home screen, navigate to:
Copy >Separator Sheets
Note: Set Collate to “1,2,3 - 1,2,3” to place separator sheets between copies. If Collate is set to “1,1,1
- 2,2,2,” then the separator sheets are added to the end of the copy job. For more information, see
Collating copies.
4. Select one of the following:
- Between Copies
- Between Jobs
- Between Pages
- Off
5. Touch
>Copy It.
Copying multiple pages onto a single sheet
In order to save paper, you can copy either two or four consecutive pages of a multiple-page document
onto a single sheet of paper.
Notes:
• Make sure to set the paper size to letter, legal, A4, or JIS B5.
• Make sure to set the copy size to 100%.