Develop ineo 4020 - Configuring Printer Hard Disk Encryption

User's Guide
- 245 -
3. Touch Restore Factory Defaults > Erase Hard Disk, and then touch one of the following:
- Single Pass Erase—This lets you overwrite the disk with all zeroes in a single pass.
- Multiple Pass Erase—This lets you overwrite the disk with random bit patterns several times,
followed by a verification pass. A secure overwrite is compliant with the DoD 5220.22-M standard
for securely erasing data from a hard disk. Highly confidential information should be wiped using
this method.
4. Touch Yes to proceed with disk wiping.
Notes:
- A status bar will indicate the progress of the disk wiping task.
- Disk wiping can take from several minutes to more than an hour, during which the printer will be
unavailable for other user tasks.
5. Touch Back > Exit Config Menu.
The printer will perform a power-on reset, and then return to normal operating mode.
Configuring printer hard disk encryption
Enable hard disk encryption to prevent loss of sensitive data in the event the printer or its hard disk is
stolen.
Note: Some printer models may not have a printer hard disk installed.
Using the Embedded Web Server
1. Open a Web browser, and then type the printer IP address in the address field.
Notes:
- View the printer IP address on the printer home screen. The IP address appears as four sets of
numbers separated by periods, such as 123.123.123.123.
- If you are using a proxy server, then temporarily disable it to load the Web page correctly.
2. Click Settings >Security >Disk Encryption.
Note: Disk Encryption appears in the Security Menu only when a formatted, non-defective printer
hard disk is installed.
3. From the Disk encryption menu, select Enable.
Notes:
- Enabling disk encryption will erase the contents of the printer hard disk.
- Disk encryption can take from several minutes to more than an hour, during which the printer will
be unavailable for other user tasks.
4. Click Submit.