User's Guide
- 246 -
Using the printer control panel
1. Turn off the printer.
2. Hold down 2 and 6 while turning the printer on. Release the buttons only when the screen with the
progress bar appears.
The printer performs a power-on sequence, and then the Configuration menu appears. When the
printer is fully turned on, a list of functions appears on the printer display.
3. Touch Disk Encryption >Enable.
Note: Enabling disk encryption will erase the contents of the printer hard disk.
4. Touch Yes to proceed with disk wiping.
Notes:
- Do not turn off the printer during the encryption process. Doing so may result in loss of data.
- Disk encryption can take from several minutes to more than an hour, during which the printer will
be unavailable for other user tasks.
- A status bar will indicate the progress of the disk wiping task. After the disk has been encrypted,
the printer will return to the Enable/Disable screen.
5. Touch Back >Exit Config Menu.
The printer will perform a power-on reset, and then return to normal operating mode.
To Next Page
Loading...
