Develop ineo 4020 - Wireless Menu

User's Guide
- 165 -
Wireless menu
Note: This menu is available only in printers connected to an Ethernet network and printers with a
wireless network adapter attached.
To access the menu, navigate to either of the following:
• Network/Ports >Standard Network >Standard Network Setup >Wireless
• Network/Ports >Network [x] >Network [x] Setup >Wireless
Use
To
Wi-Fi Protected Setup (WPS)
Start Push Button Method
Start PIN Method
Establish a wireless network connection and enable network security.
Notes:
• Start Push Button Method connects the printer to a wireless
network when buttons on both the printer and the access point
(wireless router) are pressed within a given period of time.
• Start PIN Method connects the printer to a wireless network
when a PIN on the printer is entered into the wireless settings of
the access point.
Enable/Disable WPS Auto-detection
Enable
Disable
Automatically detect the connection method that an access point with
WPS uses—Start Push Button Method or Start PIN Method.
Note: Disable is the factory default setting.
Network Mode
BSS Type
Infrastructure
Ad hoc
Specify the network mode.
Notes:
• Infrastructure is the factory default setting. This lets the printer
access a network using an access point.
• Ad hoc configures a wireless connection directly between the
printer and a computer.
Compatibility
802.11b/g
802.11b/g/n
Specify the wireless standard for the wireless network.
Note: The 802.11b/g/n is the factory default setting.
Choose Network
Select an available network for the printer to use.
View Signal Quality
View the quality of the wireless connection.
View Security Mode
View the encryption method for the wireless network.