Develop ineo 4020 - Job Prints from the Wrong Tray or on the Wrong Paper

User's Guide
- 304 -
Action
Yes
No
Step 1
1. Make sure the size of the paper loaded in the tray matches the fuser
type.
Note: Use a 110-volt fuser for printing on letter-size paper and a 220-
volt fuser for printing on A4-size paper.
2. Resend the print job.
Does the print speed increase?
The problem is
solved.
Go to step 2.
Step 2
1. Replace the fuser. For more information on installing the fuser, see the
instruction sheet that came with the part.
2. Resend the print job.
Does the print speed increase?
The problem is
solved.
Contact technical
support.
Job prints from the wrong tray or on the wrong paper
Action
Yes
No
Step 1
1. Check if you are printing on paper that is supported by the tray.
2. Resend the print job.
Did the job print from the correct tray or on the correct paper?
The problem is
solved.
Go to step 2.
Step 2
1. From the Paper menu on the printer control panel, set the paper size
and type to match the paper loaded in the tray.
2. Resend the print job.
Did the job print from the correct tray or on the correct paper?
The problem is
solved.
Go to step 3.