Develop ineo 4020 - Solving Copy Problems

User's Guide
- 335 -
Solving copy problems
Copier does not respond
Scanner unit does not close
Poor copy quality
Partial document or photo copies
Copier does not respond
Action
Yes
No
Step 1
Check if an error or status message appears on
the display.
Does an error or status message appear?
Clear the error or
status message.
Go to step 2.
Step 2
Check if the power cord is plugged into the
printer and a properly grounded electrical outlet.
Is the power cord plugged into the printer and a
properly grounded electrical outlet?
Go to step 3. Connect the power cord to the printer
and a properly grounded electrical outlet.
Step 3
Turn off the printer, then wait for about 10
seconds, and then turn it back on.
Did Performing Self Test and Ready
appear?
The problem is
solved.
Contact technical support.