Develop ineo 4020 - Additional Printer Setup; Installing Internal Options

User's Guide
- 29 -
5—Additional printer setup
Installing internal options
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional
hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug
the power cord from the electrical outlet before continuing. If you have other devices attached to the
printer, then turn them off as well, and unplug any cables going into the printer.
Available internal options
• Memory card
- EM-P04 Expanded Memory Unit 1GB
- EM-P03 Expanded Memory Unit 2G
- UK-P01 Upgrade Kit 256MB User Flash
• Font
- UK-P06 Upgrade Kit Traditional Chinese Font Card
- UK-P05 Upgrade Kit Simplified Chinese Font Card
- UK-P04 Upgrade Kit Korean Font Card
- UK-P07 Upgrade Kit Japanese Font Card
• Firmware cards
- UK-P10 Upgrade Kit Forms and Bar Code
- UK-P11 Upgrade Kit IPSD eMMC Card
• HD-P05 Hard Disk
• Internal Solutions Ports (ISP)
- EK-P02 Parallel 1284-B Interface
- NC-P02 Network Interface Card Marknet 8350 Wireless
- EK-P03 RS-232C Serial Interface Card
Accessing the controller board
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional
hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug
the power cord from the electrical outlet before continuing. If you have any other devices attached to the
printer, then turn them off as well, and unplug any cables going into the printer.