Develop ineo 4020 - Page 161

User's Guide
- 161 -
Use
To
Mac Binary PS
On
Off
Auto
Set the printer to process Macintosh binary PostScript print jobs.
Notes:
• Auto is the factory default setting.
• Off filters print jobs using the standard protocol.
• On processes raw binary PostScript print jobs.
Standard Network Setup or
Network [x] Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
Display and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a
wireless network.
Reports menu
To access the menu, navigate to either of the following:
• Network/Ports >Standard Network >Standard Network Setup >Reports
• Network/Ports >Network [x] >Network [x] Setup >Reports
Use
To
Print Setup
Page
Print a report containing information about the network printer settings, such as the TCP/IP
address.