Develop ineo 4020 - Page 185

User's Guide
- 185 -
Use
To
Timeouts
Prolong Screen Timeout
On
Off
Show a message that lets you reset the screen timeout timer
instead of returning to the home screen.
Note: Off is the factory default setting.
Timeouts
Print Timeout
Disabled
1–255
Set the amount of time in seconds the printer waits to receive
an end-of-job message before canceling the remainder of the
print job.
Notes:
• 90 is the factory default setting.
• When the timer expires, any partially printed page still in
the printer is printed, and then the scanner checks to see
if any new print jobs are waiting.
• Print Timeout is available only when using PCL emulation.
This has no effect on PostScript emulation print jobs.
Timeouts
Wait Timeout
Disabled
15–65535
Set the amount of time in seconds the printer waits for
additional data before canceling a print job.
Notes:
• 40 is the factory default setting.
• Wait Timeout is available only when the scanner is using
PostScript emulation. This has no effect on PCL emulation
print jobs.
Timeouts
Job Hold Timeout
5–255
Set the amount of time the printer waits for user intervention
before it holds jobs that require unavailable resources and
continues to print other jobs in the print queue.
Notes:
• 30 is the factory default setting.
• This menu item appears only when a printer hard disk is
installed.
Error Recovery
Auto Reboot
Reboot when idle
Reboot always
Reboot never
Automatically reboot the printer.
Note: “Reboot when idle” is the factory default setting.