Develop ineo 4020 - Page 218

User's Guide
- 218 -
Use
To
Temperature
-4 to 4
Enable the user to specify “warm” or “cool” outputs. "Cool” values generate a
bluer output than the default while “warm” values generate a redder output than
the default.
Note: 0 is the factory default setting.
Print Settings menu items and their descriptions
Use
To
Copies
1–999
Specify a default number of copies for each print job.
Note: 1 is the factory default setting.
Paper Source
Tray [x]
MP Feeder
Manual Paper
Manual
Envelope
Set a default paper source for all print jobs.
Note: Tray 1 is the factory default setting.
Collate
1,1,1 - 2,2,2
1,2,3 - 1,2,3
Stack the pages of a print job in sequence when printing multiple copies.
Note: “1,2,3 - 1,2,3” is the factory default setting.
Sides (Duplex)
1 sided
2 sided
Specify whether prints are on one side or on both sides of the page.
Note: “1 sided” is the factory default setting.
Duplex Binding
Long Edge
Short Edge
Define binding for duplexed pages in relation to the page orientation of the printed document.
Notes:
• Long Edge is the factory default setting. This assumes binding along the long edge of the
page (left edge for portrait and top edge for landscape).
• Short Edge assumes binding along the short edge of the page (top edge for portrait and
left edge for landscape).
Paper Saver
Orientation
Auto
Landscape
Portrait
Specify the orientation of a multiple-page document.
Note: Auto is the factory default setting. The printer chooses between portrait and landscape.