Develop ineo 4020 - Page 263

User's Guide
- 263 -
Notes:
• When Jam Assist is set to On, the printer automatically flushes blank pages or pages with partial
prints to the standard bin after a jammed page has been cleared. Check your printed output stack for
discarded pages.
• When Jam Recovery is set to On or Auto, the printer reprints jammed pages. However, the Auto
setting does not guarantee that the page will reprint.
Jam access
area
Printer control panel message
What to do
1
Automatic
document
feeder (ADF)
[x]-page jam, open automatic feeder top
cover. [28y.xx]
Remove all paper from the ADF tray,
and then remove the jammed paper.
2
Standard bin
[x]-page jam, clear standard bin. [20y.xx]
Remove the jammed paper.
3
Front door [x]-page jam, open front door. [20y.xx] Open the front door, then remove the
toner cartridge and imaging unit, and
then the jammed paper.
4
Multipurpose
feeder
[x]-page jam, clear manual
feeder. [25y.xx]
Remove all paper from the multipurpose
feeder, and then remove the jammed
paper.
5
Tray 1
[x]-page jam, remove tray 1 to clear
duplex. [23y.xx]
Pull out tray 1 completely, then push the
front duplex flap down, and then remove
the jammed paper.
Note: You may need to open the rear
door to clear some 23y.xx paper jams.
6
Tray [x]
[x]-page jam, remove tray [x]. [24y.xx]
Pull out the indicated tray, and then
remove the jammed paper.
7
Rear door
[x]-page jam, open rear door. [20y.xx]
Open the rear door, and then remove
the jammed paper.