D-Show Guide46
Snapshots
The Snapshots page provides several snapshot preference set-
tings to optimize D-Show Snapshot operation.
Snapshot General Preferences
The following settings are available in the Snapshots page.
Default Crossfade Time Defines the length of time it takes
D-Show to crossfade between fader levels when recalling snap-
shots.
PRE
The options in the PRE section let you specify which parame-
ters are recalled with Snapshots whose scope includes Pre set-
tings. Click to toggle whether recalled Input snapshot data in-
cludes the following:
• Gain, Pad, and Phase
• +48V (phantom power)
• Delay
• HPF
Aux Mon and Aux FX
These settings let you classify individual Aux Sends or Variable
Group Sends (or linked bus pairs) as monitor sends (“Mon”) or
as effects sends (“FX”), which lets you scope each type sepa-
rately from the Snapshots page.
This option is for organizing Aux Sends and Variable Group
Sends for snapshot control only, and does not directly affect
Aux bus or Variable Group bus operation.
MTC (MIDI Time Code)
The MIDI Time Code options let you control MTC operational
modes, frame rate, and Start Time.
Modes Available MTC modes are MTC Off, MTC Read (slave),
and MTC Generate (master).
Frame Rate This option sets the frame rate that is used when
generating MTC.
Start Time This option sets the start time that is used when
generating MTC.
MIDI
Designates the channel on which snapshots send or receive
MIDI Bank Select and Program Change information.
Snapshots Send on Channel This option sets snapshots to send
Bank Select and Program Change commands on selected MIDI
channel.
Snapshots Respond to Channel This option sets snapshots to
respond to incoming Bank Select and Program Change com-
mands on the selected MIDI channel
MIDI Snapshot Output Safe Safes (shuts off) D-Show MIDI out-
put of when snapshots are recalled. This does not affect send-
ing of Bank Select and Program Change commands with the
Snapshots Send on Channel option.
Misc
The Miscellaneous page provides utility and other settings.
Oscillator
Lets you choose the tone, frequency, and level for the built-in
oscillator.
While the Oscillator is set to Variable Sine, pressing the Osc
encoder momentarily changes the Osc encoder function from
level to frequency.
Snapshots tab of the Options page
See Chapter 21, “Snapshots.”
See Chapter 22, “Synchronization.”
Misc tab of the Options page
To Next Page
Loading...
Need help?
General
