(i) Remove oil pump, gasket, and input clutch
assembly to gain access to and install proper #4
thrust plate.
CAUTION: If view through input speed sensor hole
is not as shown in (Fig. 128), the input clutches
assembly is not seated properly.
Fig. 127 No. 4 Thrust Plate
1 - OVERDRIVE SHAFT ASSEMBLY
2 - #4 THRUST PLATE (SELECT)
3 - PETROLATUM (FOR RETENTION)
Fig. 128 View Through Turbine Speed Sensor Hole
1 - TRANSAXLE COOLER LINE
2 - TURBINE SPEED SENSOR HOLE
Fig. 129 Remove Oil Pump O-Ring
1 - OIL PUMP ASSEMBLY
2 - O-RING
Fig. 130 Measure Input Shaft End Play Using Tool
8266—Typical
1 - TOOL 8266–8
2 - TOOL 8266–2
3 - TOOL C-3339
21 - 42 TRANSAXLE LH
42LE AUTOMATIC TRANSAXLE (Continued)
To Next Page
Loading...
