(40) Install input clutch assembly with proper
thrust plate (Fig. 131).
(41) Install #1 caged needle bearing (Fig. 132).
(42) Replace cooler by-pass valve if transmission
failure has occurred (Fig. 133).
CAUTION: By-pass valve must be replaced if trans-
mission failure occurs.
NOTE: To align oil pump, gasket, and case during
installation, use threaded dowels or phillips screw-
drivers.
(43) Install oil pump gasket (Fig. 134).
Fig. 131 Install Input Clutch Assembly
1 - INPUT CLUTCH ASSEMBLY
Fig. 132 Install Caged Needle Bearing
1 - #1 CAGED NEEDLE BEARING
2 - NOTE: TANGED SIDE OUT
Fig. 133 Install By-Pass Valve
1 - BYPASS VALVE
Fig. 134 Install Oil Pump Gasket
1 - BELL HOUSING
2 - OIL PUMP GASKET
LH TRANSAXLE 21 - 43
42LE AUTOMATIC TRANSAXLE (Continued)
To Next Page
Loading...
