(44) Install oil pump and torque oil pump-to-case
bolts to 28 N·m (250 in. lbs.) (Fig. 135).
(45) Install long stub shaft and bearing to housing
(Fig. 136).
NOTE: Install new halfshaft retainer clips.
(46) Install long stub shaft bearing retaining snap
ring (Fig. 137). Replace halfshaft retainer clips.
(47) Install low/reverse accumulator as shown in
(Fig. 138).
Fig. 135 Install Oil Pump Attaching Bolts
1 - BELLHOUSING
2 - OIL PUMP
Fig. 136 Install Long Stub Shaft To Bellhousing
1 - LONG STUB SHAFT
2 - SPECIAL TOOL 8420A
3 - SLIDE HAMMER C-3752
Fig. 137 Install Long Stub Shaft Snap Ring
1 - SNAP RING
2 - SNAP RING PLIERS
3 - LONG STUB SHAFT
Fig. 138 Install Low/Reverse Accumulator
1 - ACCUMULATOR PISTON
2 - SEAL RINGS
3 - RETURN SPRINGS
4 - (NOTE NOTCH)
21 - 44 TRANSAXLE LH
42LE AUTOMATIC TRANSAXLE (Continued)
To Next Page
Loading...
