Dodge Intrepid - Page 624

(12) Loosen outer adjuster (Fig. 166).
(13) Remove differential side cover, and carrier/
ring gear assembly (Fig. 167). If differential disas-
sembly is not required, refer to Step 14.
DIFFERENTIAL DISASSEMBLY
(1) Remove ring gear-to-carrier bolts (Fig. 168).
(2) Using a plastic or soft-tipped hammer, tap ring
gear off of carrier (Fig. 169).
Fig. 166 Loosen Outer Adjuster
1 - OUTER ADJUSTER
2 - SPECIAL TOOL 6503
Fig. 167 Remove Differential Side Cover, Carrier and
Ring Gear Assembly
1 - RING GEAR
2 - TRANSAXLE CASE
3 - SIDE COVER
Fig. 168 Remove Ring Gear Bolts
1 - RING GEAR BOLTS
2 - RING GEAR
Fig. 169 Tap Off Ring Gear
1 - DIFFERENTIAL CARRIER
2 - RING GEAR
3 - PLASTIC MALLET
LH TRANSAXLE 21 - 77
FINAL DRIVE (Continued)