Dodge Intrepid - Page 659

CAUTION: Compress return spring just enough to
remove or install snap ring.
(18) Using Tool 5059A and an arbor press, com-
press UD clutch piston enough to remove snap ring
(Fig. 278) (Fig. 279).
(19) Remove spring retainer (Fig. 279).
(20) Remove UD clutch piston (Fig. 280).
(21) Remove input hub tapered snap ring (Fig.
281).
Fig. 278 UD Spring Retainer Snap Ring
1 - SNAP RING PLIERS
2 - ARBOR PRESS RAM
3 - SNAP RING
4 - SPECIAL TOOL 5059A
Fig. 279 UD Return Spring and Retainer
1 - UNDERDRIVE SPRING RETAINER
2 - SNAP RING
3 - SEAL
4 - PISTON RETURN SPRING
Fig. 280 Underdrive Clutch Piston
1 - PISTON
Fig. 281 Input Hub Tapered Snap Ring
1 - INPUT SHAFT
2 - INPUT HUB SNAP RING (TAPERED SIDE UP WITH TABS IN
CAVITY)
3 - SNAP RING PLIERS
21 - 112 TRANSAXLE LH
INPUT CLUTCH ASSEMBLY (Continued)