(5) Install the input hub/shaft assembly. to the
OD/Reverse piston/clutch retainer ashy. (Fig. 294).
(6) Install input hub tapered snap ring (Fig. 295).
Make sure snap ring is fully seated.
(7) Install UD clutch piston (Fig. 296).
(8) Install UD piston return spring and Tool 5067
as shown in (Fig. 297).
Fig. 294 Install Input Shaft Hub Assembly
1 - PUSH DOWN TO INSTALL INPUT SHAFT HUB ASSEMBLY
(ROTATE TO ALIGN SPLINES)
2 - OD/REV. PISTON
Fig. 295 Install Input Hub Tapered Snap Ring
1 - INPUT SHAFT
2 - INPUT HUB SNAP RING (TAPERED SIDE UP WITH TABS IN
CAVITY)
3 - SNAP RING PLIERS
Fig. 296 Underdrive Clutch Piston
1 - PISTON
Fig. 297 Seal Compressor Special Tool 5067
1 - PISTON RETURN SPRING
2 - SPECIAL TOOL 5067
3 - INPUT CLUTCH RETAINER
21 - 116 TRANSAXLE LH
INPUT CLUTCH ASSEMBLY (Continued)
To Next Page
Loading...
