Dodge Intrepid - Page 664

(9) Using Tool 5059A and an arbor press, install
the UD spring retainer and snap ring. (Fig. 298) (Fig.
299) Compress just enough to install snap ring.
CAUTION: Compress return spring just enough to
install snap ring.
(10) Install the UD clutch pack (four fibers/four
steels) (Fig. 300). Leave the top disc out until after
the snap ring is installed.
(11) Install the UD clutch flat snap ring (Fig. 301).
Fig. 298 UD Return Spring and Retainer
1 - UNDERDRIVE SPRING RETAINER
2 - SNAP RING
3 - SEAL
4 - PISTON RETURN SPRING
Fig. 299 Install UD Spring Retainer and Snap Ring
1 - ARBOR PRESS RAM
2 - SNAP RING PLIERS
3 - SNAP RING
4 - OD/REVERSE PISTON
5 - TOOL 5067
6 - TOOL 5059A
Fig. 300 Underdrive Clutch Pack
1 - CLUTCH PLATE
2 - ONE UD CLUTCH DISC
3 - CLUTCH DISC
Fig. 301 UD Clutch Flat Snap Ring
1 - UNDERDRIVE CLUTCH REACTION PLATE FLAT SNAP RING
2 - SCREWDRIVER
LH TRANSAXLE 21 - 117
INPUT CLUTCH ASSEMBLY (Continued)