Dodge Intrepid - Page 849

INSTALLATION
(1) Clean butyl material from door flange area.
(2) Place door run weatherstrip in position on win-
dow frame channel.
(3) Push door run weatherstrip into window frame
channel.
(4) Push weatherstrip into lower front channel
above door latch.
(5) Install door glass (Refer to 23 - BODY/DOOR -
FRONT/DOOR GLASS - INSTALLATION).
(6) Tighten side view mirror.
FRONT DOOR MOUNTED
WEATHERSTRIP
REMOVAL
(1) Using a fork type prying tool, disengage push
pin fasteners attaching weatherstrip to lower door
(Fig. 4).
(2) Remove weatherstrip from door.
INSTALLATION
(1) Place door mounted weatherstrip in position.
(2) Engage push pin fasteners to attach weather-
strip to lower door.
(3) Verify door alignment and seal
REAR DOOR BODY MOUNTED
WEATHERSTRIP
REMOVAL
(1) Remove door opening sill plate (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM - REMOVAL).
(2) Pull body mounted weatherstrip from fence
around door opening (Fig. 5).
INSTALLATION
(1) Position color dot on weatherstrip at the B-pil-
lar upper corner.
(2) Engage weatherstrip on the fence at upper
B-pillar and work down the B-pillar.
(3) Engage weatherstrip along the header and
down the C-pillar.
(4) Engage weatherstrip along the sill. There may
be slack material, work the slack material to the
front of the opening.
(5) Install the door opening sill plate (Refer to 23 -
BODY/INTERIOR/DOOR SILL TRIM - INSTALLA-
TION).
(6) Verify weatherstrip sealing.
Fig. 4 FRONT DOOR MOUNTED WEATHERSTRIP
1 - FRONT DOOR
2 - PUSH-IN FASTENERS
Fig. 5 REAR DOOR BODY MOUNTED
WEATHERSTRIP
1 - REAR DOOR OPENING
2 - REAR DOOR BODY MOUNTED WEATHERSTRIP
3 - PINCH FLANGE
23 - 112 WEATHERSTRIP/SEALS LH
FRONT DOOR GLASS RUN WEATHERSTRIP (Continued)