DRIP RAIL WEATHERSTRIP
REMOVAL
(1) Open front and rear doors.
(2) Remove fasteners attaching drip rail weather-
strip to body and fender tip. (Fig. 2).
(3) Remove drip rail weatherstrip from vehicle.
INSTALLATION
(1) Place drip rail weatherstrip in position on vehi-
cle.
(2) Start position clip at the fender tip.
(3) Press down till holes are align with fastener
holes in the body.
(4) Install fasteners to attach drip rail weather-
strip to roof rail.
(5) Close doors and verify fit.
FRONT DOOR GLASS RUN
WEATHERSTRIP
REMOVAL
(1) Remove door glass (Refer to 23 - BODY/DOOR
- FRONT/DOOR GLASS - REMOVAL).
(2) Loosen side view mirror.
(3) Pull weatherstrip from lower front channel
above door latch.
(4) Pull run weatherstrip from window frame
channel (Fig. 3).
Fig. 2 DRIP RAIL WEATHERSTRIP
1 - A-PILLAR
2 - WINDSHIELD
3 - FASTENERS
4 - DRIP RAIL WEATHER-STRIP
5 - FASTENERS
Fig. 3 DOOR GLASS RUN WEATHERSTRIP
1 - FRONT DOOR MOLDING
2 - GLASS RUN WEATHERSTRIP
3 - REAR GLASS RUN CHANNEL
4 - FRONT DOOR
5 - FRONT GLASS RUN CHANNEL
LH WEATHERSTRIP/SEALS 23 - 111
To Next Page
Loading...
