Setting Name Description
Remove leading space Remove leading spaces from the object.
10.
In the Barcode tab, use the settings listed below to change barcode settings.
10.
Name Description
Name Name of the selected barcode type.
Module width Set the barcode module size.
Optimize Optimise the barcode size.
Encoding mode Choose the data encoding mode.
Code page If Encoding mode is set to Code page, choose an encoding
method.
Quiet zones Select the unit of measurement that will be used to define the
size of the quiet zone/margin around the barcode:
•
Pixel
•
• Millimeter•
•
Mils
•
•
Inch
•
•
Percent.
•
Bar width reduction(%) Reduce the width of the barcode bars, to compensate for ink
spreading out on the print surface.
Left margin Add a blank space left of the barcode.
Right margin Add a blank space right of the barcode.
Top margin Add a blank space above the barcode.
Bottom margin Add a blank space below the barcode.
Must fit Choose if the barcode must fit in the bounding rectangle.
Escape sequence Enable escape sequences in the barcode data such as enter,
tab etc.
11.
Tabs are also available to change specific settings for the selected barcode type and data
11.
source type.
OPERATION
EPT077343 EN - Issue 1 - 11 November 2022 125
To Next Page
Loading...
Need help?
General
