36 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
5 Installation (Menu 2)
5.2 Date and Time (Menu 2.2)
Description of Date and
Time menu
The PSS 5000 has it's own Real Time Clock (RTC), which is used to time
stamp various events. The RTC setting can be changed via the Web, the Local
Service Panel and in some applications via the POS Protocol.
To view/change the date
and time with web
service pages
This procedure describes how to use the Service Menu in the web browser to
view/change the date and time values in the PSS 5000.
1. Select 2 Installation → 2.2 Date and Time.
The
Date and Time page appears.
2. Select the Date (yyyymmdd) and/or Time (hhmmss) fields and type in the
correct values.
3. Click ACCEPT to make the changes.
A message that confirms that the date and/or time has been changed ap-
pears.
Special protocols Some protocols need special UART features.
For example:
• Gilbarco pump (5787 baud)
• Satam 008 pump (900 baud)
• Scheidt & Backmann T02 pump
• MKS ER 3/2 pump
Due to PSS 5000 hardware limitations, it is not
possible to run 2 of the protocols listed above
on a PSS port pair that share UART hardware.
The port pairs are:
• port 13 + 21
• port 14 +22
• port 15 +23
For example, if one of the protocols listed above
is assigned to port 13, you will not be able to as-
sign any of the other protocols listed to port 21.
Point to Point PPP connections are only available on the DMB
ports. And only one DMB port can be configured
to use PPP.
Protocols Explanation
To Next Page
Loading...
Need help?
General
