58 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
5 Installation (Menu 2)
/pss_proc/sys/bel.txt.
For more information about parameter descriptions, see the Software Re-
lease Document (SRD) for the actual Application Program.
5.7.1 Memory Module (Menu 2.7.1)
Description of Memory
Module menu
From the Memory Module menu you can configure the number of memory
modules installed in the PSS 5000. This menu is only available using the local
service panel.
To configure the number
of memory modules with
local service panel
The number of memory modules, also known as peripheral devices, can be
configured using the local service panel.
1. Press to move to the INFORMATION 1 menu.
2. Press , , , , , , , to move to the PERIPHERAL CONF
2.7
menu.
3. Press the buttons in the sequence shown to move to sub-menus.
4. Use and to select the correct number of modules present.
5. Press OK.
The
NEW SETUP RESET NOW sub-menu appears
6. Press OK to make the changes to the changed parameter values.
To configure the memory
modules in the setup.ini
file using FTP
This procedure describes how to use the setup.ini file to configure the number
of memory modules present in the PSS 5000.
Note: The setup.ini file can be downloaded from or uploaded to the PSS 5000
using any FTP client (WP_FTP, CuteFTP) or from a command line us-
ing ftp.exe.
1. Download the /pss_mem/2/appl/setup.ini file.
2. Open the file with an editor and locate the heading [Peripherals].
3. Find the PaymentMemoryModuleCount parameter and change the value to
match the actual number of memory modules present in the PSS 5000.
4. Upload the modified setup.ini file to /pss_mem/2/appl in the PSS 5000.
5. Perform a Master Reset on the PSS 5000.
To Next Page
Loading...
Need help?
General
