PSS5000/TEMA/803046/05 49 of 152
PSS 5000 – Technical Manual
5 Installation (Menu 2)
• ‘To use the default user password with local service panel’ on page 49
These methods make it possible to restore the fixed passwords to the wanted
values, or to give temporary system access to a person on the site.
To use Doms password
for a day
The doms user has the same privileges as the admin user but uses a special dy-
namic "Doms password of the day". This password has 4 HEX characters (0–
9, A–F) and can be obtained by contacting Doms Support.
The PSS 5000 has a password validation routine in the Legal Authority Mod-
ule with fixed user_id/password combinations. The default password for all
users is "password".
To use the default user
password with local
service panel
All original user default passwords (password) can be re-enabled temporarily
from the Local Service Panel. This enables a technician, who has access to an
open box, to always get access to the system. Protection of the physical access
to the room or the box itself is outside the scope of this documentation. The
box can be behind a locked door or the box can be locked. The default pass-
words will be active until disabled manually again from the Local Service Pan-
el or until the end of the current day. This procedure describes how to use the
Local Service Panel to select the default user password of the PSS 5000.
1. Press to move to the INFORMATION 1 menu.
2. Press , , , , , to move to the DEFAULT PASSWORD 2.4.1
menu.
3. Press to move to the ENABLE D.PASSW? menu.
4. Use the and buttons to toggle between YES and NO.
5. Select YES and press OK to make the changes.
5.4.2 Name and Number (Menu 2.4.2)
To change the system
name and number
This procedure describes how to use the Service Menu in the web browser to
change the system name and number for the PSS 5000.
To Next Page
Loading...
Need help?
General
