PSS5000/TEMA/803046/05 57 of 152
PSS 5000 – Technical Manual
5 Installation (Menu 2)
5. Prepare the PSS 5000 for the software upload by typing:
ftp> get ok2load.txt
The Application program stops and the PSS 5000 board is reset.
6. Wait 5 seconds until the PSS 5000 reboots and the BOOT program starts.
During the reboot the current FTP session is closed.
7. Start a new FTP session and log on to the PSS 5000 by typing:
User <IP address:<none>>: admin
Password: password
User logged in
8. Go to the pss_mem/1/prg directory by typing:
ftp> cd pss_mem/1/prg
9. Upload the new program files to the PSS 5000 by typing:
ftp> put <program file name>.bin
The PSS 5000 reboots automatically once the upload of the new software
is complete.
Note: Remember that the files must be uploaded in the order: BOOT, LAM, AP-
PLICATION.
10. Repeat Steps 7. through 9. to upload the remaining software files.
11. After the reboot is complete, reconnect to the PSS 5000 and view the
load_rsp.txt file to verify that the new program file is present by typing:
User <IP address:<none>>: admin
Password: password
User logged in
ftp >
cd pss_mem/2/sys
ftp > get load_rsp.txt
5.7 Peripheral Configuration (Menu 2.7)
To change the setup.ini
file using FTP
To overcome limitations in some POS interfaces, a set-up file (setup.ini which,
for example, contains device pre-configuration) can be uploaded. The set-
up.ini file can be downloaded from and/or uploaded to the PSS 5000 using any
FTP client (WP_FTP, CuteFTP) or from a command line using ftp.exe.
Note: If a device item is pre-configured in the setup.ini file, the specified value
is always used. The POS interface controls the remaining items. The
POS still needs to send the usual configuration messages.
1. Download the file /pss_mem/2/appl/setup.ini.
2. Edit the pre-configuration for those devices that need to be pre-configured
in the setup.ini file.
3. Upload the modified setup.ini file to /pss_mem/2/appl in the PSS 5000.
4. Perform a Master Reset on the PSS 5000.
Note: This prepares the PSS 5000 for the new setup.ini file, which is not de-
leted during a Master Reset.
5. Syntax errors in the setup.ini file are reported in the file
To Next Page
Loading...
Need help?
General
