62 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
6 Operation (Menu 3)
1. Select 3 Operation → 3.1 Enter Fallback Mode.
The
Set Fallback Mode page appears.
2. Select Fallback Mode.
3. Click OK.
The PSS 5000 is now in Fallback mode and will remain there until an op-
erational POS forces it back to normal operation.
To set Fallback Mode
with local service panel
This procedure describes how to use the Local Service Panel to select the Fall-
back Mode in the PSS 5000.
1. Press to move to the INFORMATION 1 menu.
2. Press , , to move to the FALLBACK MODE 3.1 menu.
3. Press the buttons in the sequence shown below to move to the sub-menu
and view/change the Fallback mode value.
4. Use the and buttons to change between YES and NO.
5. Press OK.
When
YES is selected, the system is set in Attendant Fallback Mode and re-
mains in this mode until an operational POS is detected.
Note: The function will vary depending on the application. Refer to the Software
Release Document for details about the actual application.
6.2 Grade Prices (Menu 3.2)
To set view/change
grade prices with web
service pages
This procedure describes how to use the Service Menu in the web browser to
view/change the prices for the individual product grades.
To Next Page
Loading...
Need help?
General
