PSS5000/TEMA/803046/05 87 of 152
PSS 5000 – Technical Manual
8 Diagnostics (Menu 5)
4. Use the navigation buttons to navigate through the various tests.
•
Back: change the Text ID to the one prior to the ID number shown in
the
Text id field.
•
Start: Start a test sequence that shows all the texts present in the text
bank. The sequence starts at Text id 1.
•
Pause: Stops the test sequence until Start is used to continue the test se-
quence from the Text id where it was paused.
•
Forward: Change the Text ID from the ID shown in the Text id field to
the next ID number in the sequence.
•
Stop: Stops the test sequence and returns the Text id field to 1.
•
Go To: Use this button if you want to jump directly to a specific Text id.
8.2 System Logs (Menu 5.2)
Overview of System
Logs information
From the System Logs menu you can see several types of log information. The
menu is divided into the following sub-menus:
• ‘8.2.1 Upload Log (Menu 5.2.1)’ on page 87
• ‘8.2.2 Reset Logs (Menu 5.2.2)’ on page 88
• ‘8.2.3 Application Log (Menu 5.2.3)’ on page 92
• ‘8.2.4 Access Log (Menu 5.2.4)’ on page 93
• ‘8.2.5 Board Error Log (Menu 5.2.5)’ on page 94
8.2.1 Upload Log (Menu 5.2.1)
Description of the Upload
Log menu
The Upload Log menu provides a record of when the LAM and application
software were uploaded to the PSS 5000. Each record contains a date stamp,
the software version number and an ID of the user who made the upload.
To view the Upload Log
with web service pages
This procedure describes how to use the Service Menu in the web browser to
view the upload log for the PSS 5000.
To Next Page
Loading...
Need help?
General
