Doms PSS 5000 User Manual

40 of 152 PSS5000/TEMA/803046/05
PSS 5000 – Technical Manual
5 Installation (Menu 2)
To view the MAC
address of the Ethernet
module with local service
panel
This procedure describes how to use the Local Service Panel to view the MAC
address of the Ethernet module in the PSS 5000.
1. Press to move to the INFORMATION 1 menu.
2. Press , , , , to move to the TCP/IP SETUP 2.3.1 menu.
3. Press the buttons in the sequence shown below to move to the sub-menus
and view the MAC address of the Ethernet module in the PSS 5000.
5.3.2 Service Port Setup (Menu 2.3.2)
Description of service
port setup
The Service Port Setup menu enables you to set up the communication param-
eters for the Service Port present on the CPU board. The Service Port is a serial
interface port, and the following parameters must be defined:
Note: The values underlined are the default values.
Parameter Values
Baud rate 900, 19200, 38400
, 57600, 115200
PPP device modem, NULL modem

Doms PSS 5000 Specifications

General

Brand	Doms
Model	PSS 5000
Category	Controller
Language	English