PSS5000/TEMA/803046/05 37 of 152
PSS 5000 – Technical Manual
5 Installation (Menu 2)
To view/change the date
and time with local
service panel
This procedure describes how to use the Local Service Panel to view/change
the date and time values in the PSS 5000.
1. Press to move to the INFORMATION 1 menu.
2. Press , , to move to the DATE & TIME 2.2 menu.
3. Press the buttons in the sequence shown below to move to the sub-menus
and view/change the date and time values in the PSS 5000.
5.3 Communication Setup (Menu 2.3)
Overview of
Communication Setup
menu
The Configuration Setup menu is divided in to the following sub-menus:
• ‘5.3.1 TCP/IP Setup (Menu 2.3.1)’ on page 37
• ‘5.3.2 Service Port Setup (Menu 2.3.2)’ on page 40
• ‘5.3.3 Datalink Timeout for Serial Driver (Menu 2.3.3)’ on page 42
• ‘5.3.4 Service Port Protocol (Menu 2.3.4)’ on page 43
• ‘5.3.5 Menu 2.3.5 – Reserved for Future Use’ on page 43
• ‘5.3.6 Dialup Setup/Test (Menu 2.3.6)’ on page 44
• ‘5.3.7 Online/Offline Event Time (Menu 2.3.7)’ on page 45
5.3.1 TCP/IP Setup (Menu 2.3.1)
Description of TCP/IP
Setup menu
Configuration of the TCP/IP parameters must be done in accordance with the
IP address plan for the location. In order to avoid conflicts with other network
devices, consult your network administrator regarding this subject. The
To Next Page
Loading...
Need help?
General
