Page 14 of 112
DMM-0200 Product User Guide
159 Swanson Road
Boxborough, MA 01719
Tel: 508-475-3400
Email: sales@dovermotion.com
Customer Responsibilities
Requirements for the Installation Site
For installation of the DMM-0200, you are responsible for supplying the following:
An electrical receptacle available for power to the system. See “Electrical Receptacle” on page 16 for
specifications.
Warning: If you use a different type of power cord, plug, or receptacle, other than those
specified in the guide, you are responsible for having a qualified electrician install them.
Warning: If the system voltage is different than what is specified in the guide, you are
responsible for having a qualified electrician rewire the system power supplies PWS1-4 and
the main transformer T1 for that voltage.
A suitable bench area for the DMM-0200. See bench specifications in the Table 1.
One 2.0 USB cables (optional).
Note: The USB cable is not required for the initial installation since the system software is
already installed on the DMM-0200 when shipped. This cable is for customer use.
Preliminary Steps
Perform the following preliminary steps to prepare for the installation:
1. Complete the Site Requirements Checklist. See Site Requirements section.
Note: Do not attempt to perform an installation unless the requirements specified in this guide
have been carried out.
To Next Page
Loading...
