Dover DMM-0200 - Chapter 8 -Interactive Commands & USB Communications; About this Chapter; Introduction; Topics

Page 88 of 112
DMM-0200 Product User Guide
159 Swanson Road  Boxborough, MA 01719  Tel: 508-475-3400  Email: sales@dovermotion.com
Chapter 8
Interactive Commands & USB Communications
About This Chapter
Introduction
This chapter describes the USB communications and ASCII commands in detail to communicate to the DMM-0200.
Previous sections explain the communication with the PMX-2EX-SA software. The user does not necessarily need to
use the PMX-2EX-SA software to communicate to the DMM-0400. Visual BASIC, Visual C++, Labview, Matlab or
other software can communicate to the DMM-200 through the USB connection. The command set described in this
section are interactive commands that are sent through the USB port
Topics
This chapter covers the following topics:
Topic
Page
USB Communication Description
89
Motion Control Overview and Interactive Command Description
91
ASCII Programming Language
103
Error Codes
108
Where to Go Next
109