Draytek Vigor2860 - Page 763

Vigor2860 Series User’s Guide
74
9
n=-1: Always-on
n=1 ~ 999: Idle time for offline (default 180 seconds)
-i <ip address> It means that PPPoE server will assign an IP address specified here
for CPE (PPPoE client).
If you type 0.0.0.0 as the <ip address>, ISP will assign suitable IP
address for you. However, if you type an IP address here, the router
will use that one as a fixed IP.
-w <ip address> It means to assign WAN IP address for such connection. Please type
an IP address here for WAN port.
-n <netmask> It means to assign netmask for WAN connection. You have to type
255.255.255.xxx (x is changeable) as the netmask for WAN port.
-g <gateway> It means to assign gateway IP for such WAN connection.
-V It means to view Internet Access profile.
-C <sim pin code> Set (PPP mode) SIM PIN code (max. 15 characters).
-O <init string> Set (PPP mode) Modem Initial String (max. 47 characters).
-T <init string2> Set (PPP mode) Modem Initial String2 (max. 47 characters)
-D <dial string> Set (PPP mode) Modem Dial String (max. 31 characters).
-v <service name> Set (PPP mode) Service Name (max. 23 characters).
-m <ppp username> Set (PPP mode) PPP Username (max. 63 characters).
-o <ppp password> Set (PPP mode) PPP Password (max. 62 characters).
-e n Set (PPP mode) PPP Authentication Type.
n= 0: PAP/CHAP (default),
1: PAP Only
-q n (PPP mode) Index(1-15) in Schedule Setup-One
-x n (PPP mode) Index(1-15) in Schedule Setup-Two
-y n (PPP mode) Index(1-15) in Schedule Setup-Three
-z n (PPP mode) Index(1-15) in Schedule Setup-Four
-Q <mode> Set (PPP mode or DHCP mode) WAN Connection Detection Mode.
<mode>
0: ARP Detect;
1: Ping Detect
-I <ping ip> Set (PPP mode or DHCP mode) WAN Connection Detection Ping IP.
<ping ip>= ppp.qqq.rrr.sss: WAN Connection Detection Ping IP
-L n Set (PPP mode) WAN Connection Detection TTL (1-255) value.
-E <sim pin code> Set (DHCP mode) SIM PIN code (max. 19 characters).
-G <mode> Set (DHCP mode) Network Mode.
<mode>
0: 4G/3G/2G;
1: 4G Only;
2: 3G Only;
3: 2G Only
-N <apn name> Set (DHCP mode) APN Name (max. 47 characters)
-U n (DHCP mode) MTU(1000-1440)
E
E
x
x
a
a
m
m
p
p
l
l
e
e
>internet -M 1 -S tcom -u username -p password -a 0 -t -1 -i 0.0.0.0
WAN1 Internet Mode set to PPPoE/PPPoA