Draytek Vigor2860 - Page 875

Vigor2860 Series User’s Guide
861
value It is used to apply FXO country settings.
0: "use system country"
1: "Taiwan"
2: "Germany"
3: "Sweden"
4: "France"
5: "Switzerland"
6: "Holland"
7: "Finland"
8: "Denmark"
9: "UK"
10: "Australia"
12: "Italy"
14: "Red_China"
15: "Singapore"
17: "Spain"
18: "Portugal"
20: "Poland"
21: "Czech"
22: "Hungary"
23: "Slovenia"
25: "Slovakia"
37: "Brasil"
61: "US"
voip dsp setfxoringl
value It is used to configure detection ring voltage threshold to apply to
FXO.
Available setting include:
0 : use driver default value
1 : Minimum voltage threshold: 25V
2 : Minimum voltage threshold: 35V
3 : Minimum voltage threshold: 45V
Note: This function is supported only by special mode.
voip dsp setfxoCid
value Set FXO detect caller ID type.
It is available only for the model with FXO port.
voip dsp cidplusdigit
[1/0] [channel] [value] Set the substitution (0~9) for '+' digit in caller ID.
1 – enable the substitution.
0 – disable the substitution.
channel – 0 (FXS 1) -1 (FXS 2)
value – 0 – 9
voip dsp setRingThres
port Set the threshold for ring signal.
Port setting is “0” only.
value Available settings 0-250. Unit is ms.
The time is an approximate value.
voip dsp setCidDetGain
tx|rx gain Set the gain value of caller ID detected.
Tx gain – Available settings -24 ~ 12. Default is 0.
Rx gain – Available settings -24 ~ 12. Default is -6.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> voip dsp countrytone ?
VoIP has been disable. Please enable VoIP first.