on: None.
off: PAP or CHAP.
backup_wait Set waiting time after boot if USB WAN is in backup mode. This
waiting time is reserved for the dial of main WANs so that the
backup USB WAN will not go up first.
Available setting is from 1 to 255. Unit is second.
pipe It is for RD debug only. Please don’t use it without our advice.
wakeup [on/off] It is for RD debug only. Please don’t use it without our advice.
vid Set VID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
pid Set PID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
status Display current status of USB modem.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wan modem pin 0000
> wan modem status
Modem Link Speed=0
Current Signal Strength=0
Last Fail Message:
Current Connect Stage:
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
a
a
n
n
v
v
d
d
s
s
l
l
This command allows you to configure display current VDSL status and configure the fallback
mode for WAN connection.
S
S
y
y
n
n
t
t
a
a
x
x
wan vdsl [show basic]
wan vdsl[fbk_mode]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
show basic It means to display current VDSL status.
fbk_mode It means to display current status of Fallback Mode used.
Available modes to be set as fallback mode include,
Auto
Vdsl_only
Adsl_only
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wan vdsl show basic
ADSL
Link Status: TRAINING
Firmware Version: 05-04-04-04-00-01
ADSL Profile:
Basic Status Upstream Downstream Unit
To Next Page
Loading...
