Draytek Vigor2860 - Page 903

Vigor2860 Series User’s Guide
889
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
a
a
n
n
l
l
b
b
This command allows you to Enable/Disable for each WAN to join auto load balance member.
S
S
y
y
n
n
t
t
a
a
x
x
wan lb [wan1/wan2/…] on
wan lb [wan1/wan2/…] off
wan lb status
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
wan1/wan2 Specify which WAN will be applied with load balance.
on Make WAN interface as the member of load balance.
off Cancel WAN interface as the member of load balance.
status Show the current status.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> wan lb status
WAN1: on
WAN2: on
WAN3: on
WAN4: on
WAN5: on
WAN6: on
WAN7: on
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
w
w
a
a
n
n
m
m
v
v
l
l
a
a
n
n
This command allows you to configure multi-VLAN for WAN and LAN. It supports pure bridge
mode (modem mode) between Ethernet WAN and LAN port 2~4.
S
S
y
y
n
n
t
t
a
a
x
x
wan mvlan [pvc_no/status/save/enable/disable] [on/off/clear/tag tag_no] [service
type/vlan priority] [px ... ]
wan mvlan keeptag[pvc_no][on/off]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
pvc_no It means index number of PVC. There are 10 PVC, 0(Channel-1) to
9(Channel-9) allowed to be configured.
However, bridge mode can be set on PVC number 2 to 9.
status It means to display the whole Bridge status.
save It means to save the configuration into flash of Vigor router.
enable/disable It means to enable/disable the Multi-VLAN function.
on/off It means to turn on/off bridge mode for the specific channel.
clear It means to turn off/clear the port.
tag tag_no It means to tag a number for the VLAN.