153
2
PDF Template
4
Programming a JOB for DC-646 Via Computer (PC Controller)
0011Duplo20160125[front] Sheet:320.0x450.0 Finished:150.0x200.0 Slit1:10.0 Cut1:20.0 CPM,RTM,SLM
* 0 0 1 *
● Notes on creating a PDF template
Messages appears for the following case.
• If a barcode is out of the specifi cations.
Layout area of the fi nished product is out
of the barcode specifi cations.
Imposed positions of the fi nished product diff er
depending on the barcode size.
If the imposed positions are out of the
specifi cations, the alert screen as shown on the
right appears.
Clicking
OK
saves barcode position as being
out of the specifi cations.
Clicking
Cancel
cancels saving PDF fi le and
JOB entering screen
reappears.
Re-enter a larger value than the one displayed
on the message for the
fi rst cut
on the
JOB
entering screen
in the
DIRECT mode
.
The value displayed here of lead
margin diff ers depending on barcode
size.
Alternatively, clear the
DC-646 Barcode
check
box on the screen of the right that appears
when clicking
SAVE
.
To Next Page
Loading...
