Duplo DC-646 - Page 55

Programming a JOB in Advanced Mode
35
Programming a JOB on the Control Panel
2
●
Example: Entering DUPLO in JOB001
1. Press the <3> key and the CURSOR (Right) key.
• Pressing the CLEAR key deletes one character.
Enter a JOB name using the NUMERIC keys, and then press the SET key.
Maximum 30 characters in the table below can be entered.
2. Press the <8> key two times and the CURSOR (Right) key.
Select a JOB number (001–250) using the NUMERIC keys or the
CURSOR (Up/Down) key and then press the SET key.
REFERENCE
The JOB number of the locked JOB is highlighted.
(→P.55 Locking a Saved JOB)
Select
Enter JOB
using the CURSOR (Up/Down) key and press
the SET key.
Select menu
Retrieve JOB
Enter JOB
Settings1
D
Enter JOB name
Job Name
DU
Enter JOB name
Job Name
JOB001entry
1: **************
2: **************
3: **************
JOB001entry
1: **************
2: **************
3: **************
Key Pressing the same key switches character.
11 ! ”$%& ’ ( )
2ABCa b c 2
3DEFde f 3
4
G
HIghi4
5
J
KL j k l 5
6MNOmn o 6
7PQRSpq r s7
8TUVtuv8
9WXYZw x y z 9
0
0
C Clear
Moves the cursor to the left.
Space, Moves the cursor to the right.