Programming a JOB in Advanced Mode
38
Enter the value for
Slit2
to
Slit6
in a similar way to step 14.
Slit6
Slit
***.*mm
(***.*-***.*)
REFERENCE
• No screen appears for the slot in which the
slitter module
is
not installed.
Slit
Enter the distance from the right edge of the document to the
position for
Slit1
using the NUMERIC keys, and press the SET
key or the CURSOR (Down) key.
Values that you can enter are displayed in (0/***.*-***.*).
Slit1
Slit
(0/***.*-***.*)
***.*mm
REFERENCE
● Simple mode: Slits are set in alphabetical order
from
Slit A
to
Slit F
.
● Advanced mode: Slits are set in numerical order
as shown in the fi gure on the
right.
ABCDEF
Document feed direction
The gutter slits
are less than
5mm. Gutter are
output on the
• The message as shown on the right appears if slit positions that
make a gutter slit less than 5 mm that is out of the specifi cations
are entered.
When this JOB is processed, gutter slits are not ejected into the
waste box but on the
exit tray
.
Change slit positions so that a gutter slit is 5 mm or more.
More than 2
gutter slits.
The gutter slits
are output on
the exit tray.
• The message as shown on the right appears if there are three
or more gutter slits.
When this JOB is processed, gutter slits are not ejected into the
waste box but on the
exit tray
.
exit tray.
To Next Page
Loading...
Need help?
General
