Operating instructions
24 Operating manual 867 Version 01.0 - 12/2012
5.2 Inserting and replacing the needle
Sequence
After changing to a needle of a different size adjust the clearance
between the hook and the needle ( Service manual Section
11.1 Adjusting the hook side clearance).
Faults caused by an incorrect hook clearance
After inserting a thinner needle:
• Missing stitches
• Thread damage
After inserting a thinner needle:
• Damage to the hook tip
• Damage to the needle
Risk of injury by the needle point and moving
parts.
Switch off the sewing machine before replacing the
needle.
Do not touch the needle point.
WARNING
Damage to the machine, needle breakage or thread dam-
age is possible through an incorrect clearance between
the needle and hook tip.
Check the clearance to the hook tip after inserting a new nee-
dle of a different size. Adjust this if necessary.
ATTENTION
To Next Page
Loading...
Need help?
General
