Operating instructions
58 Operating manual 867 Version 01.0 - 12/2012
5.13.2 Transferring a key function to the additional
switch
You can transfer one of the key functions to the additional switch.
Select a function that you require frequently to be able to switch
it on faster while sewing.
Figure 37: Transferring a key function to the additional switch
The key function is transferred by turning the screw under the key
until it is vertical. Only one function can be transferred to the
additional switch (1). Therefore only one of the screws (4) may be
in the vertical position.
Before transferring a new function, all screws must be turned
back to their horizontal basic position.
To transfer a key function:
1. Turn all screws to their basic position (2) so that the slots are
horizontal.
2. Turn the screw under the desired key 90° so that the slot is
vertical (3).
+/–
2
3
4
1
(1) - Additional switch
(2) - Screw in basic position: slot horizontal
(3) - Screw activates the additional switch (1): slot vertical
(4) - Screws for the assignment of the additional switch (1)
To Next Page
Loading...
Need help?
General
