Modem Configuration
GSM Config (continued)
SSID (Network name): This field determines the SSID of the WiFi
access point. The factory-programmed value is "UBXWifi".
Network mode: The network mode determines the IEEE 802.11 standard of the WiFi
network. The factory-programmed value is "Mixed b/g/n".
Region: This field determines the regulatory domain. Depending on the region,
specific channels are faded in or hidden. The factory-programmed value
depends on the TOBY-L2 module version.
Channel: This field determines the channel of the WiFi access point. The factory-
programmed value is "Automatic".
Encryption: This field determines the encryption of the WiFi access point. The
factory-programmed value is "WPA2".
Network key: This field is used to define the WPA/WPA2 key. The factory-programmed
value is "ubx-wifi". The key must be suitable for the encryption method.
Re-enter key: This field is used for confirming the network key to prevent
incorrect entries.
IP: This field determines the IP address of the
WiFi access point.
The factory-programmed value is "192.168.2.1".
Subnet mask: Subnet mask: This field determines the subnet mask of the WiFi
access point.
The factory-programmed value is: "255.255.255.0".
WLAN STA
"WLAN STA" configures the connectivity to an external hotspot.
Enable „WLAN STA“. (STA mode enable : on )
The router/modem is not operated as access point but as client!
System
"System" is used for several system configurations.
Connection
Manager:
This switch enables or disables the Connection Configuration Manager.
Programming
Page 83 March 2021 HYB-UM-03155-EN-03
To Next Page
Loading...
