Above Ground Model 200iX/250iX Motorcycle Dynamometer Installation Guide
3-24
POWER CARRIAGE
The power carriage replaces the standard hand crank with an electrically powered tire
carriage allowing you to easily adjust for various wheel base distances with the press of
a button. This option is ideal for dynos that are recessed where the hand crank is
difficult to access. The power carriage will also reduce the time spent making
adjustments for various length motorcycles.
For more information on using the power carriage, refer to “Using the Power
Carriage” on page 4-6.
You will need the following part:
• 82943001 Power Carriage
The power carriage motor is preset to be installed with the carriage
screwed in all the way. Do not run the motor prior to installing it on your
dyno.
To prevent possible injury, open the CPI door and set the main breaker to
the off position and unplug the dyno. Refer to Figure 3-1 for breaker
location.
REMOVING THE HAND CRANK
1 Loosen the set screw on the hand crank and remove the hand crank.
2 Using a 7/16-inch wrench, remove the two bolts securing the flange bearing.
Figure 3-24: Remove the Hand Crank
bolt
flange bearing
hand crank
To Next Page
Loading...
Need help?
General